DIGITEN Automotive Latching Push Button Switch 19mm 3/4" Automotive Waterproof Momentary Stainless Steel Metal 12V Blue LED Light Push Button Toggle Switch ON/Off

  • $9.99
    Unit price per 
Shipping calculated at checkout.


  • ✌ Easy to install, non-solder connection with screw-type terminal.
  • ✌ Brand new and high quality with stainless shell.
  • ✌ Waterproof and dustproof design, IP65 protection level can be used in wet or dusty enviroment.
  • ✌ 19mm Self-lock Momentary Push Button Switch: Push & Hold, ON; Release, OFF.
  • ✌ Widely used for a switch for various additional electric equipment and inside & outside the car, such as critical lights, chassis lamp, fog lamps, dome light, electromagnetic starter, relay, doorbell, horn button switch, PC power switch or any circuit controls.

This is a perfect choice if you are in need of a rugged push button! These metal push buttons are a very tough, small, panel-mount latching switch with an illuminated blue LED ring.

Most often latching switches are used for various additional electric equipment, inside & outside the car(Such as critical lights, chassis lamp, fog lamps, dome light)


Features & Specifications

LED color: Blue
Material: Stainless steel constructed with stainless nut
LED working voltage: DC12V
Mounting hole diameter: 19mm
Head diameter: 22mm
Depth inc contacts: 38.5mm
Switch rating: 5A/250VAC
Operation type: Self-lock(Toggle),push button to turn on;push button to turn off again
LED working method: LED ON all the time or only ON when switch is ON
Installation: Flush mount
Protection level: IP65
Contact configuration: 1NO1NC


Addition

These switches come with a rubber O-ring which makes them splash resistant but they can NOT be submerged underwater.
The project you are going to be used for, don't let current go above 5 amps. Or the switch will get warm and to be burned out.

Customer Reviews

Based on 1 review
100%
(1)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
B
Benn

I love the switch style and feel.
Here's the details:

1. The left and right tabs in the photo power the LED. With 12.7V applied, it was using 8.1mA (0.0081A). The LED illuminated regardless of which way I ran the power through it. That amount of current will take 5 days to burn 1 amp-hour from a battery.
2. The No means "normally open", and the Nc means "normally closed".
3. "Normal" means "when the pushbutton is off". "Open" means the circuit is open and no current flows through, "closed" means the circuit is closed and current flows.
4. The power comes in through the bottom tab, and if the switch is off (button not depressed), power will flow to the top tab (right hand diagram). If the pushbutton is depressed, power will flow to the center tab (left hand diagram).
5. If you want the button illuminated all the time, wire 12V to the left tab and ground the right tab.
6. If you want the button to illuminate when the button is on, connect the center and left tabs (when power goes to the using device, it will also go to the LED power).
7. If you want the button to illuminate when the button is off, connect the top tab to the left tab (when power is shut off to the using device, the top tab will power the LED).

I'm using this to run a 24V lighting setup (2X12V LED lights in series), which should be okay in theory (the switch is theoretically rated for 250VAC), but that much voltage will burn out the LED. Thus, I'll need to find a 12V source if I want to illuminate the push button, and it will be illuminated all the time if I do that.